Climax CTC-1052-QT-DT35AW, User Manual, Page: 19 / 54

16
reporting successful .

When speech reporting is set to ( 1 ), off-hook
phone for panel to regard speech reporting
successful.

Factory default is ( 0 ), Any DTMF.
Function Selection Result
(0) Any DTMF
(1) OFF-HOOK
Command 80-82
Remove Devices
 CTC-1052-QT-DT35AW can be
programmed to remove ALL previously
learnt devices by entering ( 80) followed by
(
＃
).
After entering command ( 80 ) (
＃
), the
system will immediately emit an
acknowledging beep over the phone.
Continue to hold the phone set until you
hear the second acknowledging beep after
12 seconds.
 Command 81 is used to remove Zone 1
device.
 Command 82 is used to remove Zone 2
device.
Command 93
Learn-In Silent Pendant
<NOTE>

This command is not available in
Remote Programming Mode. It is only
available in PC programming mode.

For learning Silent Pendant :
Step 1: Click the Start button besides 93#
(Learn-in Silent Device) to enter
learning mode, a “Panel in learning
mode. Please press Device Button!”
message will pop up.
Step 2: Press the Pendant Button within 20
seconds.

Learning can only be completed
within the signal reception range of
CTC-1052-QT-DT35AW.

If no signal is received within 20
secs, CTC-1052-QT-DT35AW will
emit a long beep and automatically
returns to Programming mode.
Step 3: CTC-1052-QT-DT35AW will emit 2
beeps to indicate that Silent Pendant
is learnt-in successfully.

Adding a device for a second time is
prohibited unless it is removed from
the system first.

If one long beep is emitted instead
of 2 beeps, it indicates:
 The device has already been
learnt-in.
 When the 21
st
device is attempted
to learn-in.
<NOTE>

When CTC-1052-QT-DT35AW
received the alarm signal from the
Silent Pendant, it will not emit any
warning beeps during Reporting and
Guard time period.
Command 94
Learn-In Device
<NOTE>

This command is not available in
Remote Programming Mode. It is only
available in PC programming mode.

Up to 20 devices can be learnt into CTC-
1052-QT-DT35AW by using Command #93
or #94.

The available devices that can be learnt-in
Command #93 or 94 are:
 PIR Sensor ----- PIR
 Smoke Detector ---- SD
 Carbon Monoxide ---- CO
 Fixed Panic Button ---- PB
 Wrist Transmitter ---- WTR
 Pendant Transmitter ---- WTR
 Water Sensor ---- WS
 Fall Sensor
 Carbon Dioxide Detector ---- CO2
 Temperature Sensor ---- TS