Climax AUTOBOREWELDER BW3000, Operating Manual

Page: 78 / 150

Page 62 BW3000 Operating Manual
CAUTION
Failure to properly maintain the machine will result in premature wear or
damage to the machine. Damaged caused by improper or inadequate
machine maintenance is not covered by the machine limited warranty.
5.1 M
AINTENANCE CHECKLIST
Table 5-1 lists maintenance intervals and tasks
5.2 M
AINTENANCE TASKS
Maintenance tasks are described in the following sections.
5.2.1 BoreWelder maintenance
The BoreWelder requires little maintenance when properly cared for. Preventative
maintenance is the most effective means of attaining a long service life.
T
ABLE
5-1. M
AINTENANCE INTERVALS AND TASKS
Interval Task Reference
Before and after each
use
Remove debris, oil, and moisture from machine surfaces. --
After each use
Wipe down the quill and the mating surface of the offset head assem-
bly with a clean shop towel, lightly sprayed with WD-40. Section
5.2.1.1
Periodically
Inspect the following wirefeeder components for signs of wear:
• Drive rolls
• Pressure rolls
• Geared drive roll adapters
• Axles
• Rubber isolator feet on a shop-style wirefeeder
Section
5.2.3.1
Clean the torch liners and replace as needed. Inspect the diffusers,
tips, and nozzles for wear. Inspect the torch and extension threaded
ends where they mate for dents and burrs. Section
5.2.4 on
page 66
Inspect the O-rings that seal each end of the conduit. If the O-rings are
cracked, worn or otherwise compromised, replace them.
Section
5.2.4.2 on
page 66
Wipe down the control overlay and buttons with a clean shop towel,
lightly sprayed with WD-40.
Section
5.2.5 on
page 68