Page 36
BW3000 Operating Manual
Do the following:
1. If using a radial mount: weld the 1/2–
13x3" mounting bolt to a spot approxi-
mately 14" (36 mm) from the center of the
bore to be built up (the workpiece bore).
If not using a radial mount, weld the
mounting bolt to a spot approximately 11"
(28 mm) from the center of the bore.
2. Place the adjustable base plate over the mounting bolt as shown in Figure
3-1 on page 35.
3. Secure the adjustable base to the part by installing the four spring washers
and nut (see Figure 3-2). Tighten the nut one-half turn past finger tight with
the 3/4 wrench provided.
The spring washers maintain consistent pressure on the leveling screws while you
adjust the parallelism by doing the following:
1. Screw the mounting rod into the slider hole and tighten firmly. Torque to
15 ft-lbs (20 Nm).
2. Install the locking collar (P/N 10140) 8" (203 mm) from the top of the
mounting rod. This sets the height of the BoreWelder and prevents the
equipment from inadvertently sliding down the mounting rod.
10
Leveling screw type (3)
11
Adjustment screw
12
Spring washers (see detail above)
13
1/2" (12 mm) hold-down nut
T
ABLE
3-2. S
PRING
WASHER
ALIGNMENT
COMPONENT
IDENTIFICATION
Number
Component
1
Mounting bolt
2
Spring washers
T
ABLE
3-1. A
DJUSTABLE
BASE
AND
MOUNTING
HARDWARE
COMPONENT
IDEN
-
TIFICATION
(C
ONTINUED
)
Number
Component
F
IGURE
3-2. S
PRING
WASHER
ALIGNMENT
2
1
Summary of Contents for AUTOBOREWELDER BW3000
