Multi-Appliance Comfort Control
Navigating the Controls
FAULT
CODE
RECALL
•
Press & release
SET TIME/PROGRAM
and
ENTER
simultaneously for 10 seconds to display the last fault
code.
•
Use the up arrow to display the last 4 fault codes.
SETTING DAY AND TIME
After installing batteries for the first time or replacing old batteries (RF hand held model), or after a power
cut (Low voltage hard wired model), the display will indicate OFF and the day and time when the
batteries/power were last removed.
S
ET
T
IME
Using SET TIME mode:
1.
Press
ON/OFF
to switch the controller ON.
2.
Press & hold the
SET TIME/PROGRAM
button for more
than 2 seconds until TIME flashes. A DAY will also flash
on the bottom row of the display.
3.
Press
▲
to advance to next day or
▼
for previous days.
4.
Press
ENTER
to select the day. The DAYS will stop
flashing and the HOURS segments will flash.
5.
Press
▲
to advance to next hour or
▼
for previous hours.
6.
Press
ENTER
to select hour. HOUR will stop flashing and
MINUTES will flash.
7.
Press
▲
to advance to next minute or
▼
for previous
minutes.
8.
Press
ENTER
to select minutes.
9.
Press
SET TIME/PROGRAM
to exit the time setting mode
at any stage.
12/24
HOUR CLOCK
To change between the 12 hour and 24 hour clock modes
1.
Press & hold the
SET TIME/PROGRAM
button for more
than 2 seconds until TIME flashes.
Comfort Control - PNE
Page 11