Installation Guide / SolarRoof™ SADL Bracket A1
7
Code-Compliant Planning and Installation Guide V1.0 - Complying with AS/NZS1170.2-2011 AMDT 2-2016
Installation Instruction
1. SADL Bracket A1 Installation
Position the SADL Bracket A1 on Kingspan roof full rib correctly
according to layout plan and press the bracket down to make sure
“shoulder” each side well touch on roof rib.
Release bracket after installing 4 screws.
Screw installation instruction:
1. Use a 5/16" Hex Socket.
2. Use a mains powered or cordless screwdriver with a drive speed of
3,000 RPM maximum.
3. Fit the driver bit into the screw and place it at the fastening position.
4. Apply consistently firm pressure (end load) to the screwdriver until
the screw has fastened.
NOTE:
Screws not exposed to frequent rain should be washed down with
fresh water at least every 6 months to meet the warranty conditions of
Buildex Screws.
According to the installation plan, determine the mounting position and orientation of the Tin Interface depending on
rails running parallel or perpendicular to the roof rib, then fasten the bolt with 16-20 N•m torque.
- Installation Instructions -
2. Tin Interface Installation
Rail running parallel to roof rib
Rail running perpendicular to roof rib
