Installation Guide / SolarRoof™ SADL Bracket A1
6
Code-Compliant Planning and Installation Guide V1.0 - Complying with AS/NZS1170.2-2011 AMDT 2-2016
SADL Bracket A1 with Tin Interface
SADL Bracket A1 with Tin Interface with ezClick connection
System Overview
1. Overview of SADL Bracket A1 on Kingspan Roof
1)End Clamp 2) Inter Clamp 3) ECO Rail 4) Tin interface 5) SADL Bracket A1
Note: Bracket installation is allowed on full rib of the Kingspan roof only. Installation on lap joints must be avoided.
2. Precautions during Stainless Steel Fastener Installation
Improper operation may lead to the deadlock of Nuts and Bolts. The steps below should be applied to stainless steel
nut and bolt assembly to reduce this risk.
2.1 General installation instructions:
(1) Apply force to fasteners in the direction of the thread
(2) Apply force uniformly, to maintain the required torque
(3) Professional tools and tool belts are recommended
(4) In some cases, fasteners could be seized over time. As an option, if want to avoid galling or seizing of thread, apply
lubricant (grease or 40# engine oil) to fasteners prior to tightening.
2.2 Safe Torques
Please refer to safe torques defined in this guide as shown in the figures below. In case power tools are required,
Clenergy recommends the use of low speed only. High speed and impact drivers increase the risk of bolt galling
(deadlock) If deadlock occurs and you need to cut fasteners, ensure that there is no load on the fastener before you cut
it. Avoid damaging the anodized or galvanized surfaces.
(1)
(2)
(3)
(4)
(5)
- System Overview -
