4 / 10
Clenergy China
Tel86 592 311 0088
999-1009 Min'an Rd, Huoju Hi-tech Ind. Dev. Zone
Fac86 592 599 5028
Xiang'an District 361101, Xiamen, Fujian, China
（
5
）
Avoid working at high temperatures.
3
．
Safe Torques
Please refer to safe torques defined in this guide as shown in the figure below. If
power tools are required, Clenergy recommends the use of low speed only. High
speed and impact drivers increase the risk of bolt galling (deadlock). If deadlock
occurs and you need to cut fasteners, please make sure that there is no load on the
fastener before you cut it. Avoid damaging the anodized or galvanized surfaces.
Note: Do not fasten bolts tightly until each component is adjusted properly. Repeated
fastening or unlocking will result in bolt galling / deadlock.
3.3 Installation Dimensions
All drawings and dimensions in this installation guide are for generic reference. The
PV-ezRack® Commercial Tilt
™ is to be optimized to suit specific conditions for each
project and documented in engineering drawings. As a result, major components of
the PV-ezRack® Commercial Tilt
™ may be provided in sectional sizes and lengths
that vary from those shown in this guide. The installation operations detailed in this
instruction guide remain the same regardless of the component size. In case you
need to do any on-site modifications or alteration of the system in a way that would be
different from engineering drawings, please provide marked up drawings/sketches for
Clenergy’s review prior to modification for comment and approval.
