PULSAR
®
III-P/III-PE and VI-P/VI-PE PRESSURE CABINETS
Page 7
© 2019 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 21527, Rev. I, 02/19
2.2
Connect Compressed-Air Supply Line
WARNING
Failure to observe the following before
connecting the equipment to the compressed-
air source can cause serious injury or death
from the sudden release of compressed air.
•
Lockout and tagout the compressed-air supply.
•
Bleed the compressed-air supply line.
2.2.1
Apply thread sealant to the male threads of an air
fitting that is compatible with the air-supply hose fitting, as
noted in Section 2.2.2, and
install it onto the 1-NPT air
filter located at the blast machine inlet, as shown in
Figure 4. The style of connection shown is for reference
only.
WARNING
Hose disconnection while under pressure can
cause serious injury or death. Use safety lock
pins or safety wire to lock twist-on type air-hose
couplings together and prevent accidental
separation, and also use safety cables to prevent
hose from whipping should separation occur.
Safety lock pins and safety cables are listed in
Section 9.1: Optional Accessories.
WARNING
To avoid the risk of injury from compressed air,
install an isolation valve and bleed-off valve
where the air supply is tapped into the
compressed air system. This enables
depressurization of the compressed-air line
before performing maintenance.
2.2
.
2
Install an isolation valve at the compressed-air
source to enable depressurization for service. Connect
a 1" ID or larger air line from the air source to the air
filter. A smaller-diameter hose may reduce blasting
efficiency.
2.3
Ground the Cabinet
2.3.1
To prevent static electricity buildup, attach an
external grounded wire from an earth ground to the
grounding lug on the left rear of the power module.
2.4
Connect Electrical Service
WARNING
Shorting electrical components can result in
serious injury or death from electrical shock or
equipment damage. Electrical power must be
locked out and tagged out before performing
any electrical work. All electrical work or any
work done inside a control panel or junction
box must be performed by a qualified
electrician and comply with applicable codes.
2.4.1 Standard single-phase wiring
2.4.1.1
Standard Pulsar cabinets are 120-volt single
phase. Power is supplied by a U-ground plug; plug it into
a 120-volt outlet. No additional wiring is needed; the
wiring schematic shown in Figure 5 is for reference.
WARNING
Do not use electrical adaptors that eliminate the
ground prong on 120-volt plugs. Doing so can
cause electric shock and equipment damage.
Some items removed for clarity
Figure 4
Air-Supply Hose
1" NPT Air Filter
Use safety lock pins to secure twist-on couplings.
Air Fitting
Apply thread sealant to male threads
.
Use safety cable to prevent separated hose from whipping.
Once installed, all slack must be removed from the cable.
