PULSAR
®
3D SUCTION BLAST CABINET
Page 15
© 2020 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 29374
6.5.3
Pivot the window frame up or down until tension
is off the frame tabs.
6.5.4
To remove, pull the frame out of the slots, as
shown in Figure 16.
Figure 16
6.5.5
Replace the frame in reverse order. Align the top
bolt holes with the bolts; slide the frame as necessary.
6.5.6
Set the window squarely over the window
opening. Make sure that all edges of the window are
centered, overlapping the window gasket, and that the
window is resting on the window support tabs.
6.5.7
Swing the window frame into place and tighten
the frame nuts.
6.6
LED Light Assembly
– Figure 17
Use an approved stepladder when servicing the
light assembly. Do not climb on top of the
cabinet. The cabinet top will not support the
weight of a person. Failure can result in injury
and property damage.
6.6.1
Remove light-mount cover
6.6.1.1
Turn OFF electrical power.
6.6.1.2
Remove the nut and washer that attach the light-
mount cover to the cabinet and remove the cover, as
shown in Figure 17.
Figure 17
6.6.2
Gasket replacement
6.6.2.1
Remove the four nuts and washers that attach
the light-mount cover to the cabinet and remove the
cover, as noted in Section 6.6.1. Move the light module
off the diffuser lens and remove the lens.
6.6.2.2
Remove all the old gasket material and clean the
surface of the cabinet.
6.6.2.3
Lay a section of strip gasket along the edge of the
opening and cut to length, allowing 3/4
overlap on each
end. Peel a short section of adhesive backing and adhere
the strip gasket to the top edge of the light opening, as
shown in Figure 17. Press the gasket to bond. Repeat the
process for each side, compressing the ends to seal.
6.6.3
Diffuser lens replacement
6.6.3.1
Remove the four nuts and washers that attach
the light-mount cover to the cabinet and remove the
cover, as noted in Section 6.6.1. Move the light module
off the diffuser lens and remove the lens. Inspect the
gasket and replace it, per Section 6.6.2, if it is
compressed or otherwise damaged, before centering the
new diffuser (smooth side up) over the gasket.
6.6.3.2
Set the light module on the diffuser and reattach
the cover.
6.6.4
LED light module replacement
6.6.4.1
Turn OFF electrical power and perform lockout
and tagout procedure to power supply.
6.6.4.2
Remove the light-mount cover, per Section 6.6.1.
Pivot the frame up or
down until tension is
removed from the
frame tabs.
Align tabs on frame with
slots in the cabinet door.
LED Light-Mount Cover
Holds down the light module.
LED Light Module
Nut and Washers
Gasket
Diffuser Lens
Smooth side up.
