46
Installing Rear-Facing Car Seat With Vehicle Belt
WARNING — DEATH or
SERIOUS INJURY can occur
• Not all vehicle belts are safe for use with this car seat. Read the vehicle
belt requirements section in this manual and your vehicle owner’s manual.
Step 1
Prepare car seat for Rear-Facing Installation:
• Fully recline car seat to Recline Position
3 by pulling Recline Handle out and
rotating car seat back as shown in
Figure 58
.
• Install Rear-Facing Base to bottom of
seat. See “Installing/Removing Rear-
Facing Base” on page 82.
• Remove Seat Cushion and install Anti-
Rebound Bar. See “Installing/Removing
Anti-Rebound Bar” on page 85.
Note:
This car seat can be used Rear-Facing
in recline position 2 or 3 only.
2
tation
’arrière
Orientation v
Pour ajust
Pour déverrouiller les c
maximum puis tirez sur les poignées de déverrouillage DUA.
1
3
2
Orientation
vers l’arrière
Orientation vers l’avant
•
Pour ajuster les connecteurs rigides inférieurs du DUA
: Tirez sur la poignée d’ajustement
DUA et glissez le siège dans la position souhaitée.
•
Pour déverrouiller les connecteurs rigides inférieurs du DUA
: Étirez les connecteurs au
maximum puis tirez sur les poignées de déverrouillage DUA.
• Le niveau du sol doit être dans la plage
d’inclinaison prévue pour l’âge de l’enfant.
Plage d’inclinaison
Tous les enfants orientés
vers l’arrière
1 an et plus
cuando la línea a
decuada para el
peso del niño
es paralelo a
l suelo
UTILICE
ESTA L
ÍNEA PA
RA BEB
ÉS BAJ
O 22 li
bras (1
0 kg)
UTILICE ESTA
LÍNEA PARA
LOS NIÑOS E
NTRE 22–50
libras (10 a
22.7 kg)
Viendo hacia atrás
1
3
• Para soltar los conectores inferiores del sistema LATCH rígido: Extienda totalmente los conectores
y luego tire de las manijas rojas para soltar el sistema LATCH rígido.
2
Viendo hacia adelante
Viendo
hacia atrás
El asiento inf
antil está deb
idamente inc
linado en mod
o mirando ha
cia atrás
cuando la lí
nea adecua
da para el p
eso del niño
es paralelo
al suelo
UTILICE
ESTA L
ÍNEA P
ARA BE
BÉS BA
JO 22
libras (
10 kg)
UTILICE EST
A LÍNEA PAR
A LOS NIÑO
S ENTRE 22
–50 libras (
10 a 22.7 k
g)
Viendo hacia atrás
1
3
• Para soltar los conectores inferiores del sistema LATCH rígido: Extienda totalmente los conectores
y luego tire de las manijas rojas para soltar el sistema LATCH rígido.
2
Viendo hacia adelante
Viendo
hacia atrás
El asiento in
fantil está d
ebidamente
inclinado en
modo mirand
o hacia atrá
s
Figure 58