6
P2291BA | 2020-05
Apex Tool Group
2
EN
2
Safety
2.1 Warnings and Notes
Warning notes are identified by a signal word and a picto-
gram:
•
The signal word describes the severity and probability
of the impending danger.
•
The pictogram describes the type of danger.
.
Structure Of Warnings
Symbols On The Product
Be sure that you understand their meaning before opera-
tion.
2.2 Operator training
All operators must be trained and experienced before oper-
ating the tool. The tool may only be repaired by authorized
personnel.
2.3 Intended use
The tool is a part of the APEX tightening system and is
exclusively intended for fastening and releasing threaded
fasteners.
•
Use only in connection with a nutrunner controller of
the mPro400GC series and the accessories and
cables approved by APEX.
•
Only operate with a power supply from APEX.
•
Do not use as a hammer or for re-bending.
•
Do not open it or modify it structurally.
•
Do not use it in areas where there is a risk of explo-
sion.
•
Only in EMC Limit Class A (electromagnetic immunity
for industrial areas).
2.4 Standards
It is mandatory that national, state, and local codes and
standards be followed. Other type-specific standards see
Technical Data.
2.4.1 FCC and IC compliance
This product complies with Part 15 of the FCC Rules. Any
changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this
product. Operation is subject to the following two condi-
tions:
Danger
A symbol combined with the word
Danger
indicates a hazard with a
high level of risk
which, if not avoided, will result in death or
serious injury.
Warning
A symbol combined with the word
Warning
indicates a hazard with a
medium level of
risk
which, if not avoided, could result in
death or serious injury.
Caution
A symbol combined with the word
Caution
indicates a hazard with a
low level of risk
which, if not avoided, could result in minor or
moderate injuries or environmental dam-
age.
Note
An symbol combined with the word
Note
in-
dicates a potentially harmful situation which,
if not avoided, could result in damage to the
equipment or the environment.
General notes
Includes application tips and useful infor-
mation but no hazard warnings.
Caution
Type and source of danger.
Possible consequences of non-obser-
vance.
Measures to avoid danger.
Class 2 laser product
CE compliant
The product corresponds to the pre-
scribed technical requirements in Europe.
Read all instructions.
Observe generally valid disposal guide-
lines such as, in Germany, the Electrical
and Electronic Equipment Act (ElektroG)
and the Battery Act (BattG).
CE compliant
The product corresponds to the pre-
scribed technical requirements in Europe.
