Apex Tool Group
P2291BA | 2020-05
21
9
EN
Additional messages in "Linking" mode
The regular sequence is carried out in automatic mode,
which is configured by default. Only for the emergency
mode is an emergency operation enabled or disabled via a
scan.
Reject Release active.
The Reject Release was programmed in
the control.
1. See
Navigator > Advanced > Tool
Group > Tightening > Reject
Release.
2. Depending on the programming,
unlock the tool via the external input
NOK release
or Release on Backoff.
For unlocking via the external input
NOK release
, set the external input
and synchronize it with the control.
Error in last data synchronization with
the control.
Synchronize the tool with the control
once again.
Tool has not yet been synchronized with
a control.
Synchronize the tool with the control
for the first time.
The
Tool Enable
input is missing.
1. Activate
External Tool enable
in
Process programming > Advanced
>Tool Settings
.
2. Synchronize the tool with the control
once again.
This message can only appear if in
Nav-
igator > Advanced > Tool Settings >
External release
has been activated.
No barcode was detected within the tim-
eout or an invalid barcode was read.
The display switches to
Expect barcod
.
Scan the barcode in again.
Tool waits for job from the control. If no
job within 5 seconds:
Scan the barcode in again.
Tool waits for a barcode to be scanned.
Barcode was read successfully and con-
firmed by the control.
Initialization of WLAN chip and WLAN
module.
Reject
Releas
Sync
Sync
Error
Tool
not
set
Input
Enable
Missin
Need
Part ID
Wait
barcod
enable
Expect
barcod
Barcod
accept
WLAN
init..
Optional -
XXXXXX rundowns remaining until next
service.
Optional -
Service interval—the tool is blocked. No
rundowns possible.
Return tool to
Sales & Service Cen-
ters
for service.
Linking display, if this is programmed in
the job, here link position 1 of 16 for WK-
ID 0ZZ89999.
First line: The next position to be fas-
tened.
Second line: Number of positions.
Third line: Number of repetitions at this
position in case of an NOK rundown.
Linking has been canceled without a
batch result.
Not all of the positions in the tightening
group have been programmed.
Check the Application and Tighten-
ing group selected on the control to
determine whether the tool settings
and process programming have
been carried out.
Linking result OK.
Linking result NOK.
Service
in
XXXXXX
Serv.
Interv
P 1/16
0ZZ899
99
N.Pos1
of 3
Rpl 0
Linkin
No
Result
Linking
OK
Linking
NOK