Apex Tool Group
P2398PM |
2019-12
15
Menus and Functions
3
EN
→
A new display appears with the following selection options:
The Application/Linking group can also be changed when the tool or control is offline. However, the run-
down cannot be done until the connection between tool and control has been re-established.
3.4.2
Run screen in the FastApps mode
Fig. 3-5: Run screen in FastApps mode
Display of the FastApps
Button
Description
Press the
button to select a new Application/Linking group.
must be pressed to cancel the process and return to the run screen.
Symbol
Description
Display of the currently selected FastApp.
Up to ten FastApps can be programmed. The number on the button indicates which
FastApp is selected.
Display of the tightening strategy.
•
Display of the torque shutoff. The value to the right of the symbol indicates the
shut-off torque.
•
Display of the angle shutoff. The value to the right of the symbol indicates the shut-
off angle.
•
Display if the tightening strategy is not parameterized.
Display of the currently selected FastApp. The parameters for this FastApp are used
for the tightening.
τ
15 Nm
τ
15.7 Nm
270°
3/10
1
Display of the Linking group
Display of the rundown data
Change Linking group
1
Summary of Contents for CellCore CCBA
Page 65: ......
