17
CLEARSPAN
™
STORAGE MASTER
Revision date: 05.08.19
Secure the end
panel to the inside
surface of the
frame tube using
a Tek screw and
washer.
View shows the
inside surface of
the installed end
panel.
Door Frame
End Panel
Install Tek
screw here
Secure the End Panel to the End Frame
The frame shown in the following diagrams may differ from
the actual frame. Installation steps are the same.
1. With door opening cut, secure the end panel to the door frame using Tek screws and washers. See diagram below.
NOTE:
For the exposed corners of the door frame that remain, cut out a 16" x 16" piece of material
from the
scrap
end panel material
and secure the piece to the exposed corners using Tek screws and washers (if desired).
ATTENTION:
DO NOT secure the end panel to the inside or backside of the door frame tubes
. Some doors kits use
this surface for tracks and brackets.
2. Install Tek screws and washers
from the outside
to secure the end panel to the remaining vertical and horizontal
frame members of the end wall. This keeps the end panel tight to the frame during windy conditions. See the white
dashed lines in the diagram below.
3. After securing the end panel to the end wall frame, install the door (or doors) according to the instructions included
with those components.
4. After all doors are installed according to the door manufacturer's instructions, attach the main cover.
