19
CLEARSPAN
™
VALUE LINE
Revision date: 10.05.10
..
Cover Conduits
Cover
Ends w/
Strapping
Shelter shown above may be of a different
length than actual shelter.
End panels not shown.
Side Pocket
Side Pocket
Stretch Hem Pocket
PREPARE MAIN COVER
Gather the parts:
• Pipe 1.315" x 75" swaged
• Pipe 1.315" x 73.5" plain
• Main cover
• Tek screws
Assembly Procedure
NOTE:
When handling the main cover and setting it in position, do not pull on the end straps. They will pull out of the
cover.
WARNING:
To prevent damage to the cover and to prevent serious personal injury, DO NOT attempt to install the
main cover on windy days.
1. Assemble two main cover conduits. Start each conduit assembly with one (1) plain pipe and add swaged pipes to
arrive at the correct length.
This conduit is identical to the length of the shelter.
NOTE:
Duct tape Tek screws to prevent damage to main cover.
These cover conduits are inserted into the pockets sealed into the main cover. The conduits are used to tighten and
secure the main cover.
2. After assembling the cover conduits, locate the main cover and unfold it on a clean, smooth surface near the frame.
NOTE:
Unfold the main cover with the inside surface facing up.
a. Locate all sections of pipe needed to assemble
the cover conduit.
b. Insert the swaged end of each pipe into the
plain end of another pipe until the conduit is
assembled.
c. Secure each pipe joint with a Tek screw.
3. Locate the cover ends with strapping and
align with the front and back of the shelter.
4. Insert the cover conduits into the pockets of
the main cover.