21
CLEARSPAN™ SCREEN HOUSE
Revision date: 12.19.07
The illustration above shows the main cover bonnet
and how to attach the bonnet straps to the ratchet only.
It is of a different shelter. Ratchet location may vary
slightly.
10. After the ends of the main cover are secured in the
ratchets, locate the 1" x 3' straps used to secure the
sides of the main cover to the frame.
11. Lift the main cover skirt and make a small cut through
the cover conduit pocket material above the cover
conduit at the location of a side ratchet.
9. Insert the straps from the main cover bonnet, into the
ratchets attached to the end panel conduit.
NOTE:
Do not tighten the straps completely at this
time.
MAIN COVER INSTALLATION (CONTINUED)
Ratchet
Cover
Plain Strap End
Tek Screw
NOTE:
DO NOT cut through the main cover.
Cut
through the conduit pocket only.
12. Insert a 3' section of strap through the slit and around
the cover conduit.
13. Thread the strap ends into the ratchet and slightly
tighten.
NOTE:
It may be necessary to remove excess strap if it
binds up in the ratchet.
14. Repeat the steps for the remaining ratchet or ratchets.
15. Using additional help (if needed) tighten the main cover
beginning with the ratchets along the side of the shelter
frame.
16. After the side ratchets are tightened, return to the front
and back end wall ratchets and tighten.
NOTE:
Loosen the ratchets if needed to remove
excess strap and retighten.
17. Fold the skirt of main cover down and over the ratchets
to complete the installation of the main cover.
18. Read the care and maintenance information that
follows.