CLEARSPAN
™
FABRIC STRUCTURES
23
Revision date: 06.10.11
6. Add the spin handle to the extension pipe and secure
the connection with a Tek screw.
7. With the crank assembly properly attached, test the
operation of the crank assembly. Keep the crank
assembly in the down position.
8. Continue by attaching the ratchets. Close the panel.
Panel must be in the down/closed position before you
continue.
NOTE:
Anti-billow straps will be attached
after
the
ratchets and main cover have been attached.
Extension
Pipe
5. Secure the extension pipe to the remaining end of the
universal joint using a Tek screw.
NOTE:
The extension pipe can be trimmed to the
desired length.
INSTALL ROLL-UP ASSEMBLY (continued)
MAIN COVER RATCHETS (Straight Side)
Consult the Side Profile diagrams for the correct ratchet
locations.
IMPORTANT:
If you have installed the optional front roll-up
kit, roll the panel down. Ratchets will be attached
over the
front roll-up panels
in the locations shown below.
Gather the parts:
• Ratchets (#QH1061)
• Tek screws
Complete these steps to attach the ratchets:
NOTE:
End panels and optional front panel (if equipped)
are not shown in the following diagrams.
1. Using Tek screws, attach a ratchet
to each interior leg
of the straight wall side
, below the rafter leg brace band
clamps as shown.
NOTE:
If front roll-up panels are attached, attach the
ratchets to the rafter leg
through
the panel.
Actual frame length may
differ from frame shown.
Ratchet
