34
Clear-Com HME DX210 System Guide
The letter “F” will appear when the base registry is at its maximum of 15 registered Beltpacks. You will
need to clear the registry to add a beltpac. To clear the registry power down the base. Hold down the
CLR/BND
or
RESET REGISTRATION*
button first and then power the base on when you see the
“8” on the LED display release the
CLR/BND
or
RESET REGISTRATION*
. If done successfully
you will see a small "c" on the LED display.
Spectrum Friendly Feature
Spectrum Friendly option:
Hold down the
CLR/BND (
or
RESET REGISTRATION*)
button first then press and
hold down the
REG
(or
REGISTER BELTPAC*)
button till you see the letter “A” or “L” or “H”. Then release both
buttons and quickly press the
CLR/BND
(or
RESET REGISTRATION*)
to cycle through the “A” or “L” or “H”.
options. Stop at your selection and wait for the LED display to go blank and a lower case c will appear on the status
LED.
After this procedure is performed all bases, beltpacks and headsets will need to be re-registered to the base.
2400 to 2483.5 MHz is the operating frequency range.
2401.92 to 2439.94 MHz is the operating frequency range.
2443.39 to 2481.41 MHz is the operating frequency range.
