32
Clear-Com HME DX210 System Guide
Appendix G: DX Series LED Aid
Powering on any DX base station will produce on the LED display the number “8” for approximately 3
seconds.
Blank display indicates the base is ready for operation.
You can register Beltpacks under this condition.
Single horizontal bar indicates the base is in secondary mode and registering to a base has been initiated
and successfully linked with a primary base.
You can register beltpacks in this mode
.
Two horizontal bars indicate that the base is in secondary mode and ready to be synced with a primary
base.
You cannot register beltpacks in this mode you must sync to a primary base first.
Three horizontal bars indicate the base is in secondary mode and has been linked with a primary base but
the primary base is
no longer
available to the secondary. It takes a few seconds for the secondary to
recognize that the primary is not available and revert to a primary state.
However, you can register
Beltpacks under this condition.
