24
Clear-Com HME DX210 Operating Instructions
Multiple Base Station Registration
For multiple base stations to operate in close proximity without interference, they must be properly
registered before performing other setups. After registering each base station, register each beltpack or
all-in-one headset that will be used with that base according instructions in
section 2.3.2, page 9
.
NOTE:
If using split-band operation, select the appropriate band prior to base station registration. If a
different frequency band needs to be selected to avoid interference, the primary base station must be
set to this frequency band before base station registration is started.
Register each base station and all Beltpacks and/or All-In-One Headsets as follows:
●
On one of the base stations, ensure that the primary/secondary switch is set to primary. On the
others, ensure that it is set to secondary.
NOTE:
In split band operation, there can be one primary
and up to three secondary base stations in either band.
●
Turn the primary base station power on. Register any beltpack or all-in-one headset to be used with the
primary base station, as instructed in
section 2.3.2, page 9
. Turn each beltpack or all-in-one headset
off after registering it.
●
Power on one
secondary
base station. The
STATUS
display will show a double bar, indicating the
secondary base station is ready to be registered.
Base station ready to be initialized
Small "o" indicates primary base
station is open for registration
●
Press the
REG
(register) button on the primary base station. The
STATUS
display will show a small “o”.
●
To assign a number to a secondary base station and register it, press the
REG
button on the
secondary base station. Pressing the button repeatedly cycles through the numbers 1, 2, and 3.
When the desired number appears, stop pressing and wait. While the secondary base station is
registered using the displayed number, the
STATUS
display will continue showing the secondary
number selected. When registration of the secondary base station is finished, the display will show
one bar to indicate the secondary has been registered to the primary.
Secondary 2 searching for primary
Secondary is initialized to primary
●
Press the
REG
button on the primary. The
STATUS
display will go blank.
●
Register beltpacks and all-in-one headsets to the secondary base stations as instructed in
section
2.3.2, page 9
. After registration, turn off the secondary base station and all beltpacks and all-in-one
headsets.
Double bar
Small “o”
Secondary base
number
One bar
