CleanSpace CS302, User Instructions

Page: 16 / 90

16
 Fit the Harness
Holding the harness find the two keyhole clips at the end of each elastic strap, fit these to the buttons on the inside of
each AirClip. Check that the “Front” printing on the main head strap is pointing to the mask and that there are no
twists in the straps. The two straps of the harness fit to the inside of the AirClips on the mask.
Figure 8 – Harness Fitting and Adjusting
Adjust the harness as follows:
 To move the mask up, tighten the elastic straps by sliding the cleat down the strap as shown in
Figure 8.

To adjust for a smaller head size, shorten the rear strap by using a hole further along the strap, as
shown below in Figure 9.
Figure 9 – Adjusting the harness rear strap
Figure 7 – Mask Release Button and Adjust Button