Clean Energy CE-340, Owner'S Manual, Page: 5 / 54

WARNING:
The CE-4 Burner is only approved for use on heating equipment
manufactured by Clean Energy Heating Systems. The boiler is only approved for use
with the CE-4 burner manufactured by Clean Energy Heating Systems.
WARNING:
The installation, operation, and maintenance of this equipment in the
United States must be done by qualified personnel according to instructions in the
Clean Energy Heating Systems Owner’s Manual and in accordance with all national,
state, and local codes or authorities having jurisdiction and the following standards:
ASME Section IV Boiler Code for Pressure Vessels
ASME CSD-1 Controls and Safety Devices for Automatically Fired Boilers
NFPA 30 Flammable and Combustible Liquids Code
NFPA 30A Automotive and Marine Service Station Code
NFPA 31 Installation of Oil Burning Equipment
NFPA 70 National Electrical Code
NFPA 88A Parking Structures
NFPA 88B Repair Garages
NFPA 211 Chimney’s, Fireplaces, Vents and Solid Fuel Burning Appliances
Likewise, the installation, operation, and maintenance of this equipment in Canada must
be done by qualified personnel according to instructions in the Clean Energy Heating
Systems Owner’s Manual and in accordance with all regulations and authorities having
jurisdiction and the following CSA Standards:
B139 Installatin Code for Oil Burning Equipment
B140.0 General Requirements for Oil Burning Equipment
B140.7.2 Oil Fired Steam and Hot Water Boilers for Commercial and Industrial Use
B214 Installation Code for Hydronic Heating Systems
C22.1 Canadian Electrical Code, Part 1
GUIDELINES FOR BOILER USE:
• This boiler is for industrial and/or commercial use only. This boiler is not intended
for residential use.
• Clean Energy Heating Systems boilers are listed with Underwriters Laboratories (UL)
in the U.S. and Canada to burn the following fuels:
• #2 fuel oil
• Used crankcase oil up to 50 SAE
• Used hydraulic oil
• Used automatic transmission fluid (U.S.)
• The EPA regulations for burning used oil are as follows:
• Your supply of used oil is generated on-site. You may also collect oil from
“do-it-yourself” oil changers.
• Do not mix hazardous wastes, such as chlorinated solvents, with your used oil.
• The exhaust gases of the heating equipment must be vented to the outside
with an appropriate stack system.
• The boiler is used to recycle used oil for “heat recovery”. The boiler is not
to be used in warm weather just to dispose of used oil.
• Only trained authorized personnel should service and maintain the boiler. Be sure
the boiler receives annual maintenance to ensure safe and efficient operation.
5
SAFETY CONSIDERATIONS AND GUIDELINES