Clean Energy CE-340, Owner'S Manual, Page: 22 / 54

22
Figure 19: Installing the Air Line
(1) Refer to Figure 19.
(2) mount a water trap / air regulator (adjusted to 50 psi)
and shut-off valve close to the boiler.
(3) Run a flexible hose to the air inlet on the side of the
burner. Carefully secure the air line to ensure it does
not come in contact with any hot metal surfaces.
NOTICE:
If a flexible hose is not used the air line will
need to be disconnected from the burner to swing the
front door open.
Figure 18: Connecting the Pressure Oil Line to the Connector Block
BOILER INSTALLATION
Installing the wall thermostat:
(1) Use the digital wall thermostat provided with the boiler.
(2) Mount the wall thermostat according to the instructions provided with the thermostat.
(2) Mount the thermostat on an interior wall and in a location that will be shielded from drastic
temperature changes such as a door being opened.
(3) Mount the thermostat at eye level to allow for easy viewing and adjustment.
(4) Run the thermostat cable from the wall thermostat to the T-T terminals on the boiler
control. Install a jumper wire between the T-T terminals on the primary control on the
burner.
Changing the Wall Thermostat Batteries:
(1) A low battery indicator will be displayed on the front screen to indicate low battery strength.
(2) There is about a two week time frame to replace the batteries once the indicator comes on.
(3) Follow instructions included with the thermostat to replace the batteries.
Connecting the Compressed Air Line:
ALUMINUM
CONNECTOR
BLOCK
OIL INLET PORT
(1/4" NPT)
CE70087
AIR LINE
CONNECTION
(1/4" PUSH-TO-CONNECT
TUBE FITTING)
CE70088