12
E
N
G
LI
S
H
. Alternating images from several cameras
Up to three cameras can be used (only one camera is included in the set). The
image on the screen switches between the connected cameras (intervals of 4 or 8
seconds).
a) Set the camera which is to be shown with the channel selector [CHANNEL], all
channels (cameras) at “ON” will be shown alternately.
b) If no channel is set to “ON” then only channel (camera) 1 will be shown the
whole time.
c) Interference can be heard from the loudspeakers when the picture switches to
the next camera, turn down the volume.
d) The time for alternating the images is controlled by “5” on the channel selector:
“ON”= 8 seconds, “OFF” = 4 seconds.
e) Of you only require pictures from one of the cameras: Set the channel (camera)
(1-4) to “ON” and the others to “OFF”.
8. Troubleshooting
Problem: No signal from the camera
Likely solution:
a) Check the power supply to the camera and screen.
b) Check that the contacts to the power supply are completely connected.
c) Check the same channel is tuned on both the screen and the camera.
d) Remove bad batteries from the screen (if it is battery operated)
e) Of the picture is bad but the sound is good: Change the picture settings [V-
Hold], [BRIGHT] and [CONT] on the back of the screen.
Problem: Bad signal or interference
Likely solution:
a) Adjust the angle of the antenna on the screen.
b) Change channel on both camera and screen.
c) Move or switch off the microwave oven or other wireless products which are in
the vicinity.
