16
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE AIR HAMMER
1. Hold the tool firmly, then bring the
tool towards the work at an angle
of approximately 60-70 degrees.
2. Squeeze the trigger with the chisel
in light contact with the work.
• The chisel speed is controlled by
squeezing the trigger.
3. Move slowly across the work
surface. To remove scale, rust or
other contaminants, only a light force should be required.
4. Release the trigger to stop operation, whilst maintaining contact with the
work.
5. The tool may operate briefly after the trigger is released.
NOTE:
The retaining spring has a life expectancy, depending upon the
intensity of usage. It is recommended that you procure a spare
spring for use in the event of failure occurring during the course of
a particular job.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose.
3. Shut down the compressor at the end of the work session.
Summary of Contents for X-Pro CAT202
Page 32: ......
