20
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. If another collet is to be used, undo the screw cap completely and pull out
the collet from the collet seat. Replace it with the new collet and screw the
cap loosely back on.
FITTING THE GRINDING STONE
IMPORTANT: Never use chipped or cracked grindstones.
1. Slip the shank of the chosen stone
into the collet and tighten the
screw cap finger tight.
2. Place the smaller of the two
wrenches over the collet seat to
stop the tool from rotating.
3. Use the larger wrench to fully
tighten the collet and grip the
stone in position as shown.
ADJUSTING THE SPEED
1. Set the tool speed by rotating the
control to one of the four settings.
• The numbers on the speed
control knob indicate the
speed setting when aligned
with the reference mark on the
air inlet +/-10%):
OPERATING THE DIE GRINDER
1. Slide the throttle locking lever
forward while squeezing the
trigger against the body of the
tool.
2. Allow the tool to reach full working
speed before presenting the
grinding stone to the workpiece.
Do not use excess pressure on the
grinding stone as this will shorten
its life.
1
8,300 rpm
2
13,000 rpm
3
22,000 rpm
4
25,000 rpm
Summary of Contents for X-Pro CAT202
Page 32: ......
