Clarke Metalworker CDP350V, Operating & Maintenance Instructions, Page: 19 / 36

19
OPERATION
ON/OFF SWITCH (FIG 18)
1. To turn the drill press ON, slide the
red cover guard (1) upwards to
lift it away and access the ON/
OFF buttons. Press the green
push-button (2) to start the
machine.
• As a safety feature, the ON
button cannot be pressed
without raising the guard.
2. To turn the drill press OFF, press
either the OFF button (3) if
holding the guard raised or press
the guard cover at any time.
LASER LINE ON/OFF SWITCH (FIG 19)
The laser line switch (4) is located
below the ON/OFF switch.
POSITION THE TABLE AND WORKPIECE
(FIG 19)
Always place a piece of backup
material (1) such as wood, plywood,
etc, on the table underneath the
workpiece (2).
This will prevent splintering on the
underside of the workpiece as the drill
bit breaks through.
To keep the material from spinning out
of control, it must contact the left side
(3) of the column as illustrated, or be
clamped (4) to the table.
Note: For small workpieces that cannot be clamped to the table, use a
drill press vice (not included). The vice must be securely
clamped or bolted to the table.