Clarke Metalworker CDP350V, Operating & Maintenance Instructions, Page: 17 / 36

17
TO USE THE LASER LINE (FIG 14 AND 15)
WARNING: DO NOT STARE DIRECTLY AT THE LASER BEAM! A HAZARD
MAY EXIST IF YOU DELIBERATELY STARE INTO THE BEAM, PLEASE OBSERVE
ALL SAFETY RULES.
I. Place a workpiece on the table.
2. Turn the laser switch (1) to the ON
position.
3. Lower the drill bit to meet the
workpiece (2). The two laser lines
should cross where the drill meets
the workpiece.
4. If the laser needs to be adjusted:
a. Using a 3 mm hex key, turn the
laser adjustment set screws (3)
counter-clockwise.
b. Rotate the laser light housing (4)
until the two laser lines intersect
where the drill meets the
workpiece. DO NOT stare directly
at the laser lines.
5. Re-tighten the adjustment set-
screws (3).