Clarke Metalworker CDP350V, Operating & Maintenance Instructions, Page: 15 / 36

15
ADJUSTMENTS
TO RAISE & LOWER THE TABLE (FIG 9)
1. Loosen the support lock handle (1)
and turn the crank handle (2) until
the table is at the desired height.
2. Tighten the table lock before drilling.
TO ROTATE THE TABLE (FIG 9)
1. Loosen the support lock handle (1)
& turn the table around the column
to the desired position.
Note: The rack should rotate around the
column with the table support bracket. If
the rack binds and will not rotate, slightly
loosen the set screw in the rack collar.
2. Tighten the support lock before
drilling.
TO TILT THE TABLE (FIG 10)
1. Loosen the bevel lock bolt (1).
2. Tilt the table to the desired angle,
using the bevel scale (2) as a basic
guide.
• Check the angle using a protractor
or square for greater accuracy.
3. Re-tighten the bevel lock bolt.
4. To return the table to its original
horizontal position, loosen the bevel
lock bolt (1).
5. Re-align the table to the 0° setting.
6. Tighten the bevel lock bolt with the
wrench.
INSTALL THE TABLE EXTENSION (FIG11)
1. Insert the two rods (1) of the table
extension into the channels (2) at
each side of the table.
2. Screw a wing knob (3) into the
bottom of each channel and
tighten to secure the extension to
the table.