Clarke Metalworker CDP350V, Operating & Maintenance Instructions, Page: 11 / 36

11
ASSEMBLY & ADJUSTMENTS
ASSEMBLY
WARNING: IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG THE
BENCH DRILL PRESS IN UNTIL THE MISSING OR DAMAGED PART IS
REPAIRED OR REPLACED AND ASSEMBLY IS COMPLETE.
TOOLS NEEDED FOR ASSEMBLY
• Adjustable wrench or socket set
• Cross-head screwdriver
• Hammer and block of wood
COLUMN ASSEMBLY TO BASE (FIG 1)
1. Place the column tube (1) with its
support, onto the base (2), aligning
the column support holes with the
base holes.
2. Install a bolt (3) in each column
support hole and tighten bolts using
a wrench.
TABLE & SUPPORT BRACKET (FIG 2)
1. Insert the table worm drive spindle
(2) through the table support
bracket from inside before sliding
the crank handle (1) onto the
spindle. Secure in place with the
set-screw (3).
2. Thread the table lock handles (4)
into the front and rear of the table
support bracket.
3. Take the toothed rack (6) and hold
it against the column while lowering
the table support bracket down the
column until the drive gear meshes
with the rack teeth. Wind the table
crank handle to lower the height of
the table.
4. Lower the table support bracket
and rack until the rack seats in the
top lip of the column support (7).