Page -12-
Clarke
®
Operator's Manual IMAGE 26E
MACHINE OPERATING INSTRUCTIONS
DANGER:
Failure to read the operator’s
manual before operating this
machine could result in injury to
you or to other personnel,
damage to the machine or to
other property as well.
CAUTION:
Pump damage can occur if the
pump is operated without water
in the solution tank. Do not
activate the pump if the solution
tank is empty.
Recommendations for Best Wash -n-Rinse
Cleaning Results
1.
Vacuum carpet thoroughly before cleaning.
2.
Precondition spots, stains and any high traffic
areas as needed.
3.
Clean carpet by following the instructions in this
section. See "How to Operate the Machine".
4.
After cleaning, dry carpets by using Clarke's
Direct Air carpet dryer or by using fans. Windows
should be open to assist in proper drying.
How to Operate the Machine
1.
Put water into rinse tank and cleaning solution
into the chemical tank. Clarke recommends
using Clarkare
®
Extractor Concentrate as a
cleaning solution.
Wash-n-Rinse Operating Instructions:
a.) Soap tank must be filled with liquid soap
only. It must be at the consistency similar
to that of water.
b.) Pump setting must be placed in the maximum
range.
c.) Soap concentration used for pre spray jets is
factory set at 4:1 ratio. To change
concentration, dilute soap in container 50%
water to 50% solution to equal 2:1 ratio etc.
DANGER:
Electrocution could occur if
machine is connected to an
electrical outlet that is not
properly wired or grounded.
Always use a 3-wire electrical
system connected to electrical
ground. For maximum protec-
tion, use a circuit that is pro-
tected by a ground fault circuit
interrupter (GFCI). Consult your
electrical contractor.
2.
Connect the power cord to the machine and to
the correct electrical source.
3.
Press the power switch to the "ON" position.
https://harrissupplyind.com - To Order Parts Call 608-268-8080