19
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
REPLACING CUTTER BLADES
Blades must always be fitted as a pair, and must be of the same type, only fit
blades recommended by Clarke International.
1. Turn the cutter height adjuster so that the depth of cut, registered on the
scale, is zero.
2. Remove the Angle Fence.
3. Raise the Cutter Guard arm.
4. Turn the cutter block to reveal the
five hex. socket head screws
securing the cutter blade, then
carefully remove them.
5. Remove the cutter support and
the blade.
6. Turn the cutter block by 180
degrees and repeat the process.
• ALWAYS replace cutter blades
as a pair.
NOTE:
Spare blades are available from the Clarke spares department.
Part number NXCPT1000110.
7. Replace in reverse order, and,
using a straight edge, ensure the
cutting edges are level and in line
with the table when they are at 12
o’clock.
8. Tighten the securing screws taking
care not to over-tighten them.
WARNING: REMOVE THE PLUG FROM THE MAINS POWER SUPPLY BEFORE
CARRYING OUT ANY ADJUSTMENT, SERVICING OR MAINTENANCE
WARNING: CUTTERHEAD BLADES ARE DANGEROUSLY SHARP! USE
EXTREME CAUTION WHEN INSPECTING, REMOVING, SHARPENING OR
REPLACING BLADES INTO THE CUTTERHEAD. FAILURE TO COMPLY MAY
CAUSE SERIOUS INJURY!
Summary of Contents for CPT1000
Page 24: ......
