5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
33. The hands must never be closer
than 75mm to the cutterhead
34. Never apply pressure to stock
directly over the cutterhead. This
may result in the stock tipping into
the cutterhead along with the
operator's fingers. Position hands
away from extreme ends of stock,
and push through with a smooth,
even motion. Never back
workpiece toward the infeed
table.
35. To avoid kickback, the grain must
run in the same direction you are
cutting. Before attempting to joint,
or plane, each work piece must be
carefully examined for stock
condition and grain orientation.
36. When working with a swirl grain
wood or burls, making it necessary
to plane against the grain, use a
lesser depth of cut and a slow rate
of feed.
37. Move the hands in an alternate
motion from back to front as the
work continues through the cut.
Never pass the hands directly over
the cutter knife. As one hand
approaches the knives remove it
from the stock in an arc motion
and place it back on the stock in a
position beyond the cutter knife.
38. At all times hold the stock firmly.
Summary of Contents for CPT1000
Page 24: ......
