10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
1. Place the workpiece on the bed. It must be completely stable and
supported by packing or shims where required. Pressing plates (bed blocks)
are supplied, which locate on the bed. Place the workpiece on these to
give it stability.
NOTE:
Any packing pieces or shims used MUST be capable of
withstanding the pressure that will be brought to bear, and MUST
be of sufficient size with sufficient surface area, so as to avoid the
possibility of slipping or springing out. Mating surfaces MUST be
horizontal so that the force being exerted will NOT be at an angle.
2. Close the release valve by turning
clockwise until tightly closed.
3. Select either SLOW SPEED or FAST
SPEED using the knob on the side
of the pump cover.
NOTE:
Fast speed allows faster
movement but greater effort
will be required.
4. Pump the handle or foot pedal to
bring the ram very lightly into
contact with the workpiece.
5. Manoeuvre the workpiece or
loosen the locking bolts and slide
the ram to one side so that the
desired point of contact is directly
beneath the centre of the ram.
6. Slowly pump the handle or foot
pedal so that the ram begins to
exert pressure on the workpiece.
7. Continue to pump the handle
and constantly monitor the
process, ensuring the ram and work remain completely in line and there is
no risk of slipping.
• KEEP HANDS AND FINGERS AWAY FROM PARTS THAT MAY PINCH OR SHIFT
CAUTION: DO NOT POINT LOAD SUCH ACCESSORIES AS THEY ARE NOT
DESIGNED TO TAKE THE FULL FORCE OF THE RAM IN ONE SPOT. ENSURE
THEY ARE ADEQUATELY SUPPORTED.
Summary of Contents for 7615201
Page 20: ......
