6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6. Fit the pressure gauge through the
frame and secure with the nut
supplied. Remove any protective
bung from the gauge after fitting.
7. Screw the block connector and
the connecting piece to the
pressure gauge inlet.
•We recommend sealing all threads
with PTFE tape where hydraulic oil
is to be contained. Take care not
to let any oil escape while connecting the hoses.
8. Connect the ram hose to the ram
cylinder.
9. Bolt the foot pedal to the frame
using the long bolt, spacer tube,
nut and washers.
10. Insert the bed support pins into
the holes in the frame side
supports at a height of your
choosing. Secure them in position
using the butterfly spring clips.
11. Lift the pressing bed into position
on the pins.
NOTE:
Due to the weight of the
bed, we recommend that
you get assistance from
another person.
Summary of Contents for 7615201
Page 20: ......
