11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
DESIGN FEATURES
Bypass mode
: In bypass mode, the pump recirculates the water because the
trigger of the spray gun is not being pulled. If unit is left in bypass mode for
more than two minutes, the water temperature will rise to a dangerous level
and could damage internal components of the pump.
NOTE:
Any damage to the pump due to these causes will not be
covered under warranty.
Thermal Relief Valve:
In an effort to prevent extreme damage, pumps are
equipped with a thermal relief valve. This valve will open when the
temperature inside the pump becomes too high. This valve will then release a
gush of water in an effort to lower the temperature inside the pump.
Immediately after this occurs, the valve will close.
Chemical Injection System:
This mixes cleaners or cleaning solvents with the
pressurised water to improve cleaning effectiveness.
STARTING THE MACHINE
Prior to starting, refer to your engine manual for proper starting procedures for
your engine type.
1. Make sure the engine has sufficient fuel. See page 10.
2. Check the engine oil level. See page 9.
3. Turn water supply on.
4. Set the engine switch to ‘ON’.
WARNING: FAILURE TO TURN ON THE WATER COULD CAUSE DAMAGE TO
THE PUMP.
Summary of Contents for 7330362
Page 28: ......
