8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
If the tip becomes worn then it can be replaced by undoing the tip screw and
removing the worn tip. Replace with a new tip.
.
THE SOLDER SUCKER
The Solder Sucker is used to remove
unwanted solder from a joint. The
sucker is spring loaded and is used as
follows.
• Push the plunger down until it
clicks.
• Position the tip about 3mm
away from the solder to be
removed.
• Apply heat with the iron or gun.
• When the solder is melted press
the release button. This releases the plunger and sucks the solder
into the tip.
• Dispel the unwanted solder by reloading the plunger. This will eject
the solder from the tip.
HANDS-FREE MAGNIFIER
The Hands-Free Magnifier is designed
to hold awkward small components
together so that the solder can be
applied. The magnifier has adjustable
ball joints so that the clamps and the
magnifying lens can be set in position
as required.
WARNING: THE SOLDERING TIP WILL GET EXTREMELY HOT AND REMAIN
HOT FOR A PERIOD OF TIME AFTER THE POWER HAS BEEN SWITCHED OFF.
WHEN COOLING DOWN, THE EQUIPMENT SHOULD BE PLACED ON A
STABLE SURFACE WITH THE TIP AWAY FROM ANY FLAMMABLE MATERIALS
OR MATERIALS THAT CAN BE DAMAGED BY HEAT.