59
NZ502E
English
English
Owner’
s Manual
English
Owner’
s Manual
Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)
This unit is designed for fixed installation in the
dashboard.
If the vehicle is equipped with a factory-installed
radio, install the main unit with the parts and
screws marked (
*
2). (Figure 7)
If the vehicle is not equipped with a factory-
installed radio, obtain an installation kit to install
the main unit in the following procedure.
1. Remove the screws from both side of the
main unit. Then, at either side, lift the leaf
spring until the engaging claws are released
from the holes, and slide the spring to the
direction of arrow to remove it. Repeat the
same for the other side to remove the springs
from the both sides. (Figure 6)
2. Secure the mounting brackets to the chassis
as shown in Figure 8. Holes are pre-tapped
for TOYOTA and NISSAN vehicles;
modification, such as drilling new holes, of the
mounting brackets may be required for other
models.
3. Secure the unit in the dashboard, and then
reassemble the dashboard and the center
panel.
Note:
*
1
The parts and screws with this mark are used to install radio or included in the installation kit.
*
2
The screws with this mark are enclosed in this set.
*
3
In some cases, the center panel may require some modification (trimming, filling, etc.).
*
4
If the hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or a similar tool.
MainUnit
2-Screw
Engaging claw
2-Spring
Screwdriver
Figure 6
Mounting bracket
*
1
(1 pair for the left and right
sides)
4-Hexagonal screw
*
2
(M5
×
8)
Center Panel
*
3
*
4
Figure 7
MainUnit
*
1
*
1
*
1
*
1
*
1
*
1
*
1
*
1
Summary of Contents for NZ502E
Page 65: ...NZ502E NP402E ...
