49
NZ502E
English
English
Owner’
s Manual
English
Owner’
s Manual
This menu includes: Balance, Fader, Select EQ, Sub
Woofer Ctrl, Sub Woofer Phase, High Pass Filter, low
Pass Filter, Amp Cancel and Magna Bass EX.
Balance:
Choose the desired volume for left and right
speaker.
Fader:
Choose the desired volume for front and rear
speaker.
Select EQ:
Choose the desired mode: Bass Boost,
Impact, Excite, Custom and OFF.
Sub Woofer Ctrl:
Choose the desired sub woofer gain
from 0 to 14.
Sub Woofer Phase:
Choose the sub woofer phase
normal or reverse.
High Pass Filter:
Choose the high pass filter
through/55Hz/85Hz/120Hz.
Low Pass Filter:
Choose the low pass filter
through/62Hz/95Hz/135Hz.
Amp Cancel:
Choose the amplifier audio output on
or off.
Magna Bass EX:
Choose the loudness on or off.
Navigation Setup Menu
This menu includes: GPS Time, Navi Interrupt, and
Voice Guidance
GPS Time:
Set the system time to be synchronized
with GPS local time or not.
Navi Interrupt:
There are three choose: On/Popup/
Off. “On”: The navigation screen will cover to AV
screen when reaching some key point. “Popup”: When
small turn info window will pop up in the top of the
AV screen to indicate the key point. “Off”: Turn off this
function.
Voice Guidance:
Enable or disable the navigation
voice guidance.
Voice Guidance Mix:
There are two choose: On/Off.
“On”: The navigation voice guidance will play at the
same time and the voice of the current source. “Off”:
Only the navigation voice guidance. (Voice Guidance
On ).
Others Setup Menu
This menu include: Set Password; Parental control,
Audio Language, Subtitle
Language, PTY Language, Change Language,
Blinking, TS Calibrate, and Load Factory.
Set password:
Set the password for DVD parental
control.
Parental control:
Set the rating of the age. It contains
Kid Safe/G/PG/PG- 13/PG-R/R/NC- 17/Adult.
Audio Language:
Set the Language for DVD Audio.
Subtitle Language:
Set the Language for DVD subtitle.
PTY Language:
Set the Language for PTY name.
System Language:
Set the Language for system
screen.
Blinking LED:
Select the blinking LED On/Off.
Screen Calibrate:
The function of it is to select the TS
Calibrate YES or NO.
Factory Default:
The function is to select to load
factory default or not.
Set the Anti-Theft code
1. If your unit is unlocked, hold the [
]
button
more than 2 seconds, then the Anti-Theft setting
mode will display. Users can change anti-theft code.
Click [Yes], the numerical keypad is displayed. Enter
the new password twice, then anti-theft code is set
and your unit is secured.
Summary of Contents for NZ502E
Page 65: ...NZ502E NP402E ...
