Clarion DXZ778RUSB, Owner'S Manual

Page: 16 / 51

Basic Operations
English
16
DXZ778RUSB
●
Adjusting the bass
2-1. Select “ BASS ”.
3-1. Press the [ ] button.
3-2. Push the [ P.CH ] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “
0 ”).
3-3. Press the [ ] button to return to the
previous mode.
●
Adjusting the treble
2-1. Select “ TREBLE ”.
3-1. Press the [ ] button.
3-2. Push the [ P.CH ] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “
0 ”).
3-3. Press the [ ] button to return to the
previous mode.
●
Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select “ S RESTORER ”.
3-1. Push the [ P.CH ] button upward or
downward to adjust.
Each time you push the [ P.CH ] button, the
sound restorer changes in the following
order:
“ OFF ”
↔
“ 1 ”
↔
“ 2 ”
↔
“ 3 ”
∗
The factory default setting is “ OFF ”.
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
●
Adjusting the balance
2-1. Select “ BALANCE ”.
3-1. Push the [ P.CH ] button upward to
emphasize the sound from the right
speaker, push the button downward to
emphasize the sound from the left speaker.
∗
The factory default setting is “ 0 ”.
(Adjustment range: L12 to R12)
●
Adjusting the fader
“ FADER ” can be adjusted only when the
speaker system is set to “ 2WAY ” or “ NORMAL ”.
2-1. Select “ FADER ”.
3-1. Push the [ P.CH ] button upward to
emphasize the sound from the front
speaker, push the button downward to
emphasize the sound from the rear
speaker.
∗
The factory default setting is “ 0 ”.
(Adjustment range: R12 to F12)
●
Setting high pass filter
“ HPF” can be adjusted only when the speaker
system is set to “NORMAL”.
∗
The factory default setting is “THRGH” (through).
2-1. Select “HPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting. Each time
you push the [P.CH] button, the setting
changes in the following order:
“THRGH”
↔
“50Hz”
↔
“80Hz”
↔
“125Hz”
●
Setting low pass filter
“S-W LPF” can be adjusted only when the
speaker system is set to “NORMAL”.
∗
The factory default setting is “THRGH” (through).
∗
If subwoofer function is set to “ST” or “MONO”,
“S-W LPF” can be selected.
2-1. Select “S-W LPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting.
Each time you push the [P.CH] button, the
setting changes in the following order:
“THRGH”
↔
“50Hz”
↔
“80Hz”
↔
“125Hz”
DXZ778RUSB_EN.book 16 ページ ２００６年１２月２６日 火曜日 午後２時２５分