19
Installing the Drive Eye
Method of Installation
1. Choose a place where the Drive Eye will be installed, check
carefully if the place is appropriate according to the following:
Is the place behind the rearview mirror?
Is it disturbing your sight when you drive?
Is the gap between the windshield and the mirror big enough for
adjustment of the rearview mirror?
Is the gap between the windshield and the mirror big enough for
inserting and removing the CF Card?
Can you connect the power cable properly?
Is the windshield clean and dry? (If not, clean the glass with a clean
cloth.)
Is the camera in a place where it can take clear pictures even if
using windshield wipers on rainy days?
Are you trying to install the Drive Eye on the sunshade or glass film
of the windshield? (Please install the Drive Eye directly on the
windshield.)
Is the camera angle of the Drive Eye even with the ground?
(If not, refer to Page 14 to adjust the camera angle before setup.)
Make sure that you check all the items above and go to the next stage.
NOTE
Warning
Make sure to fix the power cable with fasteners so the cable does not interfere
with your driving. If the power cable is scratched or disconnected, fire and
electric shock may be caused by a short circuit.
You cannot re-use the double-sided tape. If when mounting the Drive Eye on the
windshield, the double-sided tape gets damaged, please replace it with new
tape.
00DRIVE EYE.book Page 19 Friday, February 8, 2008 3:57 PM
