Civemasa Implementos Agrícolas
24
AACRP
Adjustments and operations
Ways to start the plowing
Entrance
Entrance
Exit
Exit
Troubleshooting guide
Regardless of the format of the field, the plowing is done in strips. To change the
direction and to do the reversion of the equipment, lift it for maneuvering.
Problem
Causes
Possible solutions
Poor
penetration.
Hard and dry soil.
Carry out the subsoiling job before plowing.
Blunt moldboard blade.
Replace it.
Third-point control valve
activation adjustment.
Consult the tractor manual to check how
to properly adjust it.
Forming ridges.
Adjust the upper arm of the third-point.
Uneven equipment.
Level the equipment according to the
instructions on the 'adjustments and
operations' section (Plow leveling page).
Poor coverage.
Tractor is far from the
furrow.
Position the tractor for a perfect finishing
job.
Blunt moldboard blade.
Replace it.
Earth getting stuck on the
polyethylene plate.
Moisture excess in the soil.
Damaged plate that must be replaced.
Equipment
pulling to the
side.
Uneven equipment.
Adjust the level according to the instructions
on the 'adjustments and operations' section
(Plow leveling page).
