Page 17 of 27
Configuration
The Lock PIN is set on this screen. Using the Lock PIN will prevent
anyone who is not authorized from accessing the Multiverse
Transmitter from their DMXcat app.
Insert any PIN from 0001 to 9999. Insert 0000 to remove PIN.
To reset a lost PIN, depress the switch inside the very small hole on
the end of the Transmitter just to the right of the Ethernet input.
Note: Holding this switch for approximately five seconds will reset
the entire Transmitter to factory defaults.
IP Settings
Interface choices are shown.
Current IP address is shown.
Current Netmask is shown.
Enable or disable DHCP (default is enabled).
DHCP status is shown.
Enable or disable Zero-configuration mode (default is enabled).
