- 13 -
Chapter 3
Loading Media In To The Printer
Paper Thickness Adjustment
By default, the Prodot 350 printer will detect the thickness of media being
used on the first line of each page. You can override the default settings
using the control panel and the printer’s configuration settings.
Details of the method of adjusting the configuration settings can be found
in Chapter 5 of this manual and in the Prodot 300 manual.
Loading Single Cut Sheets
Turn the printer on.
Then press the PARK/LOAD key
to set the paper select lever at the
cut-sheet position as shown in the
figure below.
Note: You should NOT change
this setting manually. Always use
the control panel key.
Position the left hand guide in the
correct location for the size of
paper being used.
Refer to the indications on the top
cover where the A4 and Letter size
paper sizes are indicated.
