5. Chronograph Mode
The chronograph function of this watch is able to measure time in 1/100 units for up to 99
hours, 59 minutes and 59.99 seconds. The chronograph returns to the reset display
(0:00'00"00) and stops after 100 hours have elapsed.
A. Reading the Display
<1/100 Second Display>
The digits for 1/100 seconds of the
chronograph are only displayed for 1
minute when the chronograph is started
and after returning to the measurement
display from the split time display, after
which they are no longer displayed.
However, the 1/100 second digits are also
displayed when the chronograph is
stopped and during the split time display.
B. Chronograph Timing Procedure
(1) The chronograph is repeatedly started and stopped each time button (B) is pressed.
(2) The split time is displayed for about 10 seconds when button (C) is pressed during
measurement. The most recent split time is measured and displayed each time button
(C) is pressed. ("SPL" flashes while split time is displayed.)
(3) Pressing button (C) while the chronograph is stopped returns the watch to the reset
display.
* Split time refers to the amount of time that has elapsed from the starting line to some
intermediate point.
* The watch automatically returns to the time mode when none of the buttons are pressed for
about 3 minutes during the chronograph reset display.
* The watch automatically returns to the surface mode when none of the buttons are pressed
for about 3 minutes in the chronograph mode (including during timing) when the surface mode
has been activated (while resting on the surface).
* If the mode is switched to the low power mode during chronograph timing, chronograph
timing is interrupted and the watch returns to the reset display.
30
(
C
)
(
B
)
(
D
)
(
A
)
[Chronograph Reset Display]
Hours, minutes,
seconds
1/100 seconds
Current time
After 10 seconds
(B)
(B)
(C)
(C)
Reset
Timing
Split time
Stop
