— 37 —
Change the settings of the paper near-end sensor to set the position at which
the near-end of the paper is detected.
1. Use a pointed object, such as a pen, to gently press the button to change the paper
near-end sensor.
2. Press and hold down the button whil e moving the paper near-en d sensor up, down,
right and left. The sensor positions are shown below for the various diameters of the
paper roll used.
Note:
*: Position of sensor when shipped from factory. However, factory settings differ depending on the
destination market.
3.10 Adjusting the Paper Near-end Sensor
When paper thickness is 75 µm or less
(Unit: mm)
Senso r position
Exterior diameter when detected as
near end
Exterior/ interior diameter of core
of paper roll used
A, a
Approximately
31
18/
12
B
*
, b
Approximately
23
18/
12
C
Paper near-end sensor function is off
When paper thickness is 75 µm or mor e
(Unit: mm)
Senso r position
Exterior diameter when detected as
near end
Exterior/ interior diameter of core
of paper roll used
A, a
Approximately
41
32/
25.4
B
*
, b
Approximately
34
32/
25.4
C
Paper near-end sensor function is off
CAUTION
The diameter of the roll of paper that is detected is an estimate. Some variations may
occur depending on the paper.
Button to change paper
near-end sensor
(“A” and “B” are for horizontal installations, and “a” and “b” are for vertical or
wall installations.)
V10 CONSUMIBLES S.L.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
