Citizen CBM-262 Type II, User Manual

Page: 113 / 131

7
103
Bit Printer Status
Value
0 1
0 Journal Near End Sensor Status Paper present No paper
1 Receipt Near End Sensor Status Paper present No paper
2 Journal End Sensor Status Paper present No paper
3 Receipt End Sensor Status Paper present No paper
4 Not used 0 —
5 Not defined — —
6 Not defined — —
7 Not used 0 —
Bits 2, 3:
If there is no paper at the end sensors, this printer always goes off-line,
so this command is not executed. Therefore, a status of bit 2 = 1 or bit 3 = 1 will
not be sent.
Input Data Format
(66) Sending of the status (GS r n)
Code: [1D] h + [72] h + n
* (1
≤
n
≤
2)
(31
≤
n
≤
32) Data are expressed in Hex code.
This commands sends the specified status.
n = 1, 31: Sends the paper sensor status.
n = 2, 32: Sends the drawer kick connector status.
• When the printer has Serial interface specifications:
In the case of DTR/DSR Control: After confirming that the host computer is ready
to receive, the status is sent. If it is impossible
for the host to receive, waiting continues until
it is possible for it to receive.
In the case of XON/OFF Control: The printer sends the status without confirming
if it is possible or impossible for the host com-
puter to receive.
• This command is executed during development of the receiving buffer, so if a
command is received in accordance with the receiving buffer's state, there is a
possibility of a delay occurring while the status is being sent.
• If ASB is enabled by GS a, it is necessary to distinguish between the status from
this command and the status from ASB. See pages 50~53 for the identification
method.
• Paper Sensor Status (n = 1, 31 )