Cissell L36TD30ME, Technical Manual

Page: 30 / 53

Page 30
S6162-BS-MMC-010/12489
INSTRUCTIONS FOR ALIGNING BASKET ON CISSELL 50 LB. DRYER -
D O U B L E M O T O R
1. Loosen the 4 gear reducer mounting bolts (1, 2, 3 & 4) on rear of dryer,
and 2 adjusting bolts #5, on gear reducer housing (Fig. 3).
2. Place one “A” and two “B” diameter pins inside the drying compartment
between the rim of the basket opening and the rim of the door opening in
the positions shown in Figure 1 and Figure 2. Check the two “B” pins for
equal clearance.
3. With the pins in position, tighten the two No. 5 bolts until flush against
back of dryer. Retighten gear reducer mounting bolts in the numerical
order indicated in Figure 3. Tighten lock nuts No. 6 to secure bolts No. 5
in position. Then remove pins.
4. Check the space between basket and door opening at “A” pin and “B” pin
positions (Figure 2). If the gap is not approximately the same on both
sides, repeat steps 1, 2 & 3.
NOTE: Use short sections of round steel rod for pins or drill bits may be
used in place of round rod.