Cissell L36TD30ME, Technical Manual

Page: 12 / 53

Page 12
S6162-BS-MMC-010/12489
B R E A K D O W N P R O C E D U R E
If the tumbler dryer is installed aboard ship, disconnect the electrical power leads and
steam connections going to the dryer before proceeding further.
NOTE: All wiring is to be left in place unless otherwise noted. Thermometer and
thermostat assembly is left in place.
Back channel, gear reducer, belt guard and motor assembly remains as one
complete assembly.
1. Disconnect door switch (1) by pulling two brown wire connections at Area (B)
after pulling the front door panel off (2). Disconnect the two wire leads from
the white plugs and push them thru opening in Area (B).
2. Remove front panel (2) by unscrewing 11 Phillips head bolts holding it to the
dryer. Two door switch wire leads go with front panel.
3. Remove lint door (4) by turning lock with a screwdriver.
4. Remove cover on reversing control box (6) by unscrewing 2 - hex head bolts.
Pull apart three black leads on top of this control box coming from main
disconnect (5). Disconnect the three red motor leads and three blue motor
leads and two white plugs of wires coming from Area (A). Disconnect the
Greenfield cable nuts from both motor cables and remove from control box.
Disconnect the white Molex connectors and leave in place. Disconnect motor
ground cables (green).
5. Unscrew 4 nuts holding fan motor fan and mount assembly (7) onto back of
dryer.
6. Remove two basket shaft nuts (8) on gear reducer. Then go to front of dryer
and wiggle the basket (9) fromt the dryer. The basket shaft key, 9 inches
long, might stay with shaft; if it doesn’t, remove it from gear reducer and tie
it to the shaft for later use.