Cissell L28UR30E, Owner'S Manual

Page: 34 / 64

Page 34
Service Savers
TROUBLESHOOTING To help you troubleshoot the dryer, we list below the most
common reasons for service calls and some answers to the
problems. Before you call service, please review the following
items:
DRYER WON’T START
1. Is the door completely closed?
2. Are the controls set to the “on” position?
3. Did you push the “start” control?
4. Has a fuse blown or a circuit breaker tripped?
5. Are the fuses tight?
6. Check for low voltage.
7. Has the bonnet thermostat (gas only) tripped? If so, push to
reset.
DRYER WON’T HEAT
1. Is the dryer set for “cooling time” rather than “drying
time”?
2. Are the gas valve in the dryer and the valve on the main gas
line turned on?
3. Check for low or intermittant gas pressure.
4. Check spark ignition module diagnostic light.
CLOTHES ARE NOT SATISFACTORILY DRY
1. Timed cycle—Did you allow enough heating time before
the cool-down part of the cycle?
2. Is the lint screen blocked?
3. Is the exhaust duct to the outside clean and not blocked? (A
blocked exhaust will cause slow drying and other
problems.)
GAS DRYER IGNITION
Refer to the page on “Instructions for the Direct Ignition
System Operation”. Check to see if the manual gas valve is
open. Then reset the dryer controls. All panels, covers, and
doors must be in place and closed before starting the dryer.
VERY IMPORTANT
When calling the factory for service, always refer to the
model number and serial number.
DRYER WON’T START
DRYER WON’T HEAT
CLOTHES ARE NOT
SATISFACTORILY DRY
GAS DRYER IGNITION
VERY IMPORTANT